Hello Everyone,
Our PRTG is pulling the following from ESX
Warnings 3 elements return a warning state: System Board 1 Power Optimized 0 --- 0.7.1.118; Add-in Card 3 SD1 0 --- 0.11.3.244; Add-in Card 3 SD2 0 --- 0.11.3.245
When I log into VMWare ESXi, I see that the Monitor has three Sensors that show these warnings as Unknown.
Has anybody run into a similar issue with these Sensors not showing their state in the Health Column of the Monitor? This started happening after the Image Profile was updated to DellEMC-ESXi-6.5U3-15177306-A04 (Dell)
This is the info on the ESX
